Reference • Backing Sequence mode
95
Page 6: Edit 2
In this page you can select one of the following three
operations: copy measures (COPY), combine tracks
(BOUNCE), adjust timing errors (QUANTIZE). Move
the cursor to the operation you wish to carry out using
the CURSOR buttons, then press ENTER/YES to
access the subpage.
6-1. Copy measures
This operation copies measures within a track or from
one track to another.
1. Move the cursor to the “Track” parameter, using
the CURSOR buttons and choose the track with the
TEMPO/VALUE buttons. Select ALL to erase mea-
sures from all the tracks (chord track, control track,
tempo track, keyboard track, etc.).
2. Move the cursor to the “First measure” parameter,
and choose the first measure you wish to copy.
Move the cursor to the “Last measure” parameter,
and choose the last measure you wish to copy. If
only want to copy one measure, assign the same
measure to both the parameters.
3. Move the cursor to the “Target track” parameter,
and choose the copy destination track. If you have
chosen ALL as the copy source, this parameter will
automatically be set on ALL.
4. Move the cursor to the “First target measure” and
choose the measure number.
5. Press ENTER/YES twice to confirm copying of
data. If the destination measure contains other
data, this will be erased and substituted with the
new data.
How to copy in measures with different
time signature
If the destination measures have a different time signa-
ture to the original ones, the data will remain intact,
but the time signature of the copied data will not now
coincide with the original data.
COPY
BOUNCE
QUANTIZE
Track
First measure
Target track
First target measure
Last measure
To Next Page
Loading...
Need help?
General
