Reference • Disk/Global mode
125
10. Disk/Global mode
• “Parameter modified - Write?” message
After having modified some parameters, if you press
the button of another operative mode, the question
“Parameter modified - Write?” will appear in the dis-
play.
If you wish to save the changes you have made, press
ENTER/YES twice, otherwise press EXIT/NO. If the
changes are not saved, switching the instrument off
and then on again will reset the original Global values.
The changes will be saved in memory, and kept even
when the instrument is turned off. They will be saved
in the Global file when you perform one of the follow-
ing operations:
•Save > Save All
•Save > Save Global
Changes will be loaded in memory when you perform
one of the following operations:
•Load > Load Global
•Load > Load All > All
The settings saved in memory will be saved on disk.
Therefore, before saving the Global on disk, you need
to save the Global settings in memory, using the Write
Global function contained in “Page 22: Write Global”
(see page 152).
In order to avoid drastic changes in the instrument
operation when loading data from disk, the Split Point
and Lower Memory Mode parameters will be saved in
memory when you save the Global, but will not be
saved on disk.
You can also access the Write Global function by press-
ing REC/WRITE/LYRIVS while you are in any other
page in the Disk/Global mode.
To Next Page
Loading...
Need help?
General
