Getting Started• Tutorial
31
Transposition
You can change the pitch of the real time tracks with
the semitone transposition.
Note: If the accompaniment is playing during the modifi-
cation, the transposition will enter at the beginning of the
next measure.
● To lower the real time track pitch by one or
more semitones press the TRANSPOSE [ ] button
once or more.
The sound pitch will be lowered by a semitone
each time the button is pressed.
● To raise the real time track pitch by one or more
semitones press the TRANSPOSE [ ] button
once ore more.
The sound pitch will be raised by a semitone each
time the button is pressed.
● To cancel the transposition press both TRANS-
POSE buttons together.
Selecting a Keyboard Set
By selecting a Keyboard Set in the Arrangement Play
mode, you can select the programs of the real time
tracks, the Keyboard Mode, the Keyboard Assign, the
Chord Scanning, the effects, as well as other character-
istics that would otherwise have to be programmed
one at a time.
In Arrangement Play and Song Play, the Keyboard Sets
also recall the settings of the VOCAL/GUITAR sec-
tion.
There are three banks (A, B, C) with five Keyboard Sets
each (1, 2, 3, 4, 5). Let’s try to select Keyboard Set 1 of
the C bank.
1 Press the BANK button in the KEYBOARD SET
section a few times, to turn on the C bank led.
Each time you press the BANK button, one of the
banks is selected in cyclic mode:
A
⇒
B
⇒
C
⇒
A…
2 Press button 1 of the KEYBOARD SET section.
Keyboard Set 1 of the C bank will be selected. The
programs of the real time tracks will change and
the status of Chord Scanning, Keyboard Assign,
Keyboard Mode, the effects, etc. could change, too
(depending on the data saved in the Keyboard Set).
Recording a Keyboard Set
It is possible to record the status of the real time tracks,
the effect and the VOCAL/GUITAR section in a Key-
board Set. Let’s try to record the current status in Key-
board Set 5 of the B bank.
1 Press REC/WRITE/LYRICS and press one of the
buttons in the KEYBOARD SET section.
The Write Keyboard Set page will appear.
2 Press a few times the BANK button in the KEY-
BOARD SET section to light up the B led.
3 Press button 5 in the KEYBOARD SET section.
4 Press ENTER/YES twice to save (or EXIT/NO to
cancel).
The status of the real time tracks, the effects and the
VOCAL/GUITAR section is saved in Keyboard Set
5 of the B bank. You can save the Keyboard Sets
with the Save functions in the Disk/Global mode
(see page 131).
Note: To retrieve the original Keyboard Sets, load the
Keyboard Set contained in the Accessory Disk sup-
plied.
To Next Page
Loading...
Need help?
General
