Reference • Disk/Global mode
150
Page 19: User scale
You can create four personalized scales, that you can
use by assigning the USER SCALE value to the “Page
17: Main scale” setting. You can use the User Scale as a
sub scale, assigning one of the USER SCALE values to
the “Page 18: Sub scale” setting.
User Scale
[USER SCALE 1...4]
One of the four USER scales.
Note
[C…B]
The note you wish to modify. The modifications apply
to this note on all the octaves.
Tuning
[–50…+50]
Tuning of the selected note, in 1 cent steps (1 cent =
1
/
100
of a semitone). Tuning can be changed by max. a
quarter tone above (+50) or below (-50) the standard
tuning.
Page20: MIDI data dump
The MIDI Data Dump is the sending of internal data of
the i40M to another MIDI device. In this page, you can
transmit and receive System Exclusive data.
To transmit System Exclusive data:
1. Set the System Exclusive message filter on “o”. (see
“Page 8: MIDI filter”).
2. Select the type of data you wish to send and press
ENTER/YES.
3. Write down the MIDI Global channel, which
should be the same when you wish to newly
receive the data from the external device (see “Page
5: MIDI channel settings (1)”).
To receive System Exclusive data.
1. Program the MIDI Global channel on the channel
where data has been sent. (see “Page 5: MIDI chan-
nel settings (1)”).
2. Set the System Exclusive message filter on “o”. (see
“Page 8: MIDI filter”).
3. Move to this page and start transmitting from the
external device.
Note
Tuning
Scale to be programmed
Data type
To Next Page
Loading...
Need help?
General
