Reference • Arrangement Play mode
78
Level
[0…30]
Reverb level.
Time
[0…30]
Reverb length.
Tone
[0…30]
Reverb tone. This parameter will determine the high
frequency attenuation. Higher values will give a
higher attenuation.
Page 22: NR and CR programming (Guitar mode)
This page shows the parameters of the NR (Noise
Reduction) and CR (Cabinet Resonator) effects. These
effects can be activated in “Page 16: Guitar effects (2)
(Guitar mode)”.
Note: These parameters will only be accessed if the NR
and CR parameters are not set on OFF in “Page 16: Gui-
tar effects (2) (Guitar mode)”.
NR/CR
(Noise Reduction/Cabinet Resonator)
The Noise Reduction reduces the level of the back-
ground noise (noise captured by the pick-ups, empty
strings touched by mistake). The Cabinet Resonator
simulates a guitar amplifier.
NR: Threshold
[0…30]
Level threshold under which the signal must be cut.
With too high values even the guitar sound can be cut.
CR: Size
[0…30]
This parameter determines the size of the simulated
amplifier cabinet.
Depth
[0…30]
Effect intensity.
MODE
ARR.PLAY
OCTAVETEMPO
PAGE
CHORD
ROOM Level=18
Time=07 Tone=07
M
7
MODE
ARR.PLAY
OCTAVETEMPO
PAGE
CHORD
NR:Threshold=06
CR:Size=24 Depth=13
M
7
To Next Page
Loading...
Need help?
General
