Reference • Appendices
194
13. Appendices
Messages
In the various page displays of Arrangement Play mode and Backing Sequence mode display settings and
parameters, and also when you modify settings such as volume, mute, and transpose, the iS40/iS50 will
sometimes display “popup” screens that appear only for a few seconds.
In addition to these, you may occasionally see messages that provide warnings, ask for confirmation, or indi-
cate that processing is taking place.
If a warning message is displayed, correct the settings for the measure or filename etc. as necessary, and exe-
cute the operation once again.
If a confirmation message is displayed, be aware that executing the operation may cause some or all data to be
lost from the iS40/iS50’s internal memory or from a floppy disk.
Then, either save the important data to disk or make a backup copy of the file before continuing the proce-
dure.
If one of these warning or confirmation messages appears, you should also check to make sure that the type of
operation itself that you are attempting to execute is actually the desired operation. (For example, make sure
that while intending to execute Rename Arrangement you are not actually selecting the Write Arrangement
page.)
????????.??? exists.
The filename ????????.??? that you specified as the name of a new file is
already used by a different file on the same disk. Is it OK to replace
(overwrite) the old file with the new file? If this is done, the contents of
the old file will be lost from the disk.
Already formatted. Contin-
ue?
This message notifies you that the disk you are attempting to format is
already formatted, and asks whether the operation should be contin-
ued. Make sure that you have inserted the correct disk.
Are you sure?
This message is asking whether the operation should be executed. To
execute press the ENTER/YES button. To cancel without executing
press the EXIT/NO button.
Can’t find file
During an operation such as load, delete or rename, did you exchange
disks after specifying a file?
The currently inserted floppy disk does not contain the required file.
Thus, the operation that you are attempting cannot be executed.
Make sure that the correct disk is inserted.
Can’t play all track. Contin-
ue?
The iS40/iS50 does not have enough memory to play all the tracks of
the musical data that you specified. If you playback now, some of the
tracks will not be heard.
Can’t read disk.
The currently inserted floppy disk is a format which the iS40/iS50 can-
not use, and the operation that you are currently attempting cannot be
executed.
Make sure that the correct disk is inserted. This message may also
appear if the current or voltage of your AC power is unstable.
To Next Page
Loading...
Need help?
General
