Reference • Backing Sequence mode
102
Page 10: Extra Track settings (2)
In this page you can choose the program (sound), pan
(stereo location) and the effect level sent to the two
built-in effect systems, for each of the 8 extra tracks.
Extra Track
[ETr1…ETr8]
Select the track using the buttons of the PROGRAM/
VOLUME section.
Program
[A11…U88, Dr11…Dr44]
Select the program using the buttons in the PRO-
GRAM/ARRANG section. In order to select a Drum
program (Dr11–28), press the F(USER/DRUM) button
repeatedly until the abbreviation “Dr” appears, then
select a two-digit number with the number buttons.
Pan
[OFF, L15…L01, CNT, R01…R15, PROG]
This specifies the stereo location of the track. It will
determine the levels of channels A and B.
CNT Track placed in the center.
L values Track placed to the left.
R values Track placed to the right.
OFF Track output on channels A and B
off.
PROG The pan setting of the program will
be used.
C=/D= (Effect sends)
[0…9, P]
These are the send levels for the selected track (sent by
channels C and D to the built-in effect systems).
P The send level of the program will be
used.
0-9 Send levels of channels C (usually
reverb) or D (usually modulating
effect, chorus or flanger type).
Extra Track
Program
Pan
Effect sends
To Next Page
Loading...
