Reference • Program mode
153
11. Program mode
* If you set Oscillator Type to DOUBLE (double oscil-
lator program) in “Page 2: Oscillator basic/Oscilla-
tor 2 relative”, these pages will display either the
oscillator 1 or oscillator 2 parameters. Switch
between oscillators 1 and 2 by pressing the VARIA-
TION buttons [1] and [2].
How to recover lost changes
If you accidentally select a different program without
writing your edits, you can press the TEMPO button
(if you have not yet edited the selected program) to
bring back the previous program. (Only the sound will
be brought back, and the program number will not
change.)
Page 1: Program play
In Page 1 of Program mode you can select the Program
that will be played. You can also use the Performance
Edit settings that are shown in this page to perform
simple editing.
Press the PROGRAM button to enter Program mode,
and the following display will appear.
Program
[A11…E88, F11…F88, Dr11…Dr28]
The internal memory of the i40M contains seven banks
of Programs, as follows.
Select the program using the buttons in the PRO-
GRAM/ARRANG section (see “Changing the sounds
of the real time tracks” a pagina 30). Press PRO-
GRAM/ARRANG to light up the PROGRAM led.
Select a bank first (A, B, C, D, E, F-USER/DRUM), then
enter a two-digit number, using the number buttons. If
the program is in the same bank, you only need to
select the two-digit number.
In order to select a Drum program (Dr11–28), press the
F(USER/DRUM) button repeatedly in the PROGRAM
section, until the abbreviation “Dr” appears, then
select a two-digit number with the number buttons.
You can also select programs using an optional foot-
switch or an EC5 external controller pedal. For details
refer to Disk/Global mode “Page 12: Assignable
pedal/switch” or “Page 13: EC5 external controller”.
When you select a program, a MIDI program change
message will also be transmitted.
XPOSE (Transpose)
[–11…+11]
When you need to transpose (shift the pitch), use the
TRANSPOSE buttons to set the Transpose setting of
each program. The pitch can be transposed in semi-
tone steps over a range of 11 steps up or down.
Octave
[–2…+2]
Use the OCTAVE buttons to set the Octave of each pro-
gram. With a setting of 0, the program will sound at its
standard pitch. The pitch can be shifted in steps of an
octave, over a range of 2 octaves up or down.
Bank
Number of
programs
Contents
A 64 GM programs 1–64 (ROM)
B 64 GM programs 65–128 (ROM)
C, D, E 64 × 3 i40M preset programs (ROM)
F 64 User programs (RAM)
Dr 16
Drum programs (ROM: Dr11–26,
RAM: Dr27–28)
Program
Transposition/Octave
To Next Page
Loading...
Need help?
General
