Reference • Song Edit mode
118
Page 4: Event edit
The Event Edit page allows you to modify single
events, for example notes and control change mes-
sages (pedal, volume, pan...).
The typical edit procedure is:
1. Select the track you wish to edit, press REC/
WRITE/LYRICS and then START/STOP.
2. Select the “Measure number/Index number”
parameter and go to the event you wish to edit.
Make the necessary modifications.
3. When finished, press START/STOP to exit event
edit.
Track
[01…16, TEMPO]
The track you wish to edit.
Event filter
To make viewing and searching of the event you wish
to edit easier, you can “filter” the events shown on the
display. While you are in the main page of Event Edit,
press REC/WRITE/LYRICS to access the Event Filter
page. Assign “o” to the type of events you wish to
view, “x” to the type of event that you do not wish to
view. For more information on the various types of
events, refer to the paragraph about this further on.
Press REC/WRITE/LYRICS to get back to the Event
Edit page.
Event types
● BAR (Bar line)
Measure number/Index number
The index number is the event number within the
measure. By modifying this number you can step from
one event to another within the measure. Index num-
ber 0 corresponds to the bar line (i.e. the point that sep-
arates two measures) and the time signature of the
measure.
Time signature
This indicates the time scanning of the measure, i.e.
the number of movements in which it is divided, and
the scanning unit.
● End of track
This display indicates the end of the track.
● Event
Track
“Note” events
“Control change” events
“Aftertouch” events
“Program change”
events
“Poly Aftertouch“
events
“Pitch bend”
events
Measure number / Index number
Bar line
Time signature
Position
Event type
To Next Page
Loading...
Need help?
General
