Reference • Disk/Global mode
142
Page 9: Arrangement Harmony
This page allows you to choose the harmonization
channel in the VOCAL/GUITAR section for the
Arrangement Play mode.
Ch (Channel)
[01…16]
MIDI channel on which the harmonization notes are
received.
Oct
[-3…0…+3]
Transposition octave of the harmonization notes. For
example, if you are playing the chords with your left
hand, below the split point, and you must harmonize a
female voice, you can choose a positive value (two or
three octaves) to bring the chords to the sing height.
Rng (Range)
[C-1…G9]
Lowest and highest note in the chord detection area
for harmonization in the VOCAL/GUITAR section.
This area may not coincide with the chord detection
area for the arrangement (see “Tempo and chord scan-
ning” on page 56).
Page 10: Backing Sequence Harmony
This page allows you to choose the track of the harmo-
nization chord in the VOCAL/GUITAR section for the
Backing Sequence mode.
Track
[OFF, DRUM, PERC, BASS, ACC1…3, UP1, LOW/UP2,
ETr1…8]
Track of the harmonization chord. The chord may be
generated by a recorded track or a part played in real
time (e.g. by choosing UP1 and playing on a keyboard
connected through the Global channel).
The LOW/UP2 track is normally selected. This track
allows you to play the harmonization chords with
your left hand.
ARR HARMONY Ch=01
Oct=+01 Rng=C2 ->B3
Octave
Chord detection area
MIDI channel
BSEQ HARMONY
Track=ETr8
To Next Page
Loading...
Need help?
General
