Reference • Effects
178
D (D Pan)
[OFF, R, 99:01…01:99, L]
Panning (stereo positioning) of the signal from chan-
nel D. This will only appear if SERIAL, PARALLEL 1
or PARALLEL 2 settings are selected.
L Left signal.
R Right signal.
OFF Channel D signal off.
1L/1R (Effect 1 Left/Right level)
[0…9]
This only appears if PARALLEL 3 setting is selected.
0 Effect 1 (reverb) off.
1-9 Effect 1 level (reverb). The signal will
be mixed with channels A and B (not
effected).
2L/2R (Effect 2 Left/Right level)
[0…9]
This will only appear if PARALLEL 3 setting is
selected.
0 Effect 2 level(modulating) off.
1-9 Effect 2 level 2 (modulating). The sig-
nal will be mixed with channels A
and B (not effected).
Effect 1 settings pages
Effect 2 settings pages
These pages contain the effect parameters selected on
the “Effect select” page. The parameters contained in
these pages will depend on the effects you have
selected. For more information on programming
effects, see forward in this chapter.
Dynamic modulation
If an optional Korg XVP-10 or EXP-2 pedal controller
is connected to the ASSIGN PDL/SW jack, and you set
the Disk/Global mode “Page 12: Assignable pedal/
switch” to EFFECT CONTROL, a foot pedal can be
used to control the effects in various ways. The aspect
of the effect that can be controlled will depend on the
effect; for example it might be the balance between the
original sound and processed sound, the speed of
modulation, or the frequency that is being empha-
sized.
Mode Page
Arrangement Play
“Page 12: Effect 1 settings”, “Page 13:
Effect 2 settings”
Backing Sequence
“Page 14: Effect 1 settings”, “Page 15:
Effect 2 settings”
Song Play
“Page 7: Effect 1 settings”, “Page 8:
Effect 2 settings”
Song Edit
“Page 11: Effect 1 settings”, “Page 12:
Effect 2 settings”
Program
“Page 20: Effect 1 settings”, “Page 21:
Effect 2 settings”
To Next Page
Loading...
Need help?
General
