Reference • Appendices
196
File protected.
The selected file has an attribute of read-only. Thus, the operation that
you are attempting cannot be executed.
First make sure that you have selected the correct file. The attribute of a
file on disk cannot be changed by the iS40/iS50, but you can use a per-
sonal computer to do so if you need to. If you are sure that it is OK to
change the attribute of the file, insert the disk into the disk drive of a
personal computer, modify the attribute of that file, insert the disk back
into the iS40/iS50’s disk drive, and perform the operation once again.
For details on file attributes and how to change them, refer to the
owner’s manual for your personal computer or the manual for your
computer’s operating system.
Keyboard Track Empty.
Since the keyboard track contains no data, the operation that you are
attempting cannot be executed. Either record data, or load data into the
track before attempting the operation.
Measure not exists. Contin-
ue?
Have you specified the wrong measure? The measure number that you
specified does not exist in the data.
Measure overlaps.
With the settings that you specified, the measures that you wish to copy
overlap with the copy destination.
It is not possible to make settings so that the copy destination is located
within the copy source.
Check the position and length of the copy source measures and the
number of copies, and the location of the copy destination.
Measure won’t fit.
If measures are copied or inserted as you specified, this track will
exceed 999 measures.
The iS40/iS50 cannot create more than 999 measures in a track. Check
the length of the measures that you wish to copy or insert, the number
of copies, and the length of the insert destination track.
Missing Arrangement.
There is no arrangement file in the currently inserted disk.
Missing B.Sequence.
There is no backing sequence file in the currently inserted disk.
Missing HMB file
The setup file of the VOCAL/GUITAR section is missing. The disk
probably comes from a KORG iS40. In spite of the error message, all the
other files will be loaded and no problems will occur when operating
the instrument.
Missing some files.
Some of the files are missing from the currently inserted disk.
No disk in drive.
A floppy disk is not inserted in the disk drive. Correctly insert a disk
into the drive, and try the operation again.
Not SMF.
The specified file is not a Standard MIDI File. Thus, this data cannot be
played back on the iS40/iS50. Make sure that you have not specified the
wrong file.
To Next Page
Loading...
Need help?
General
