Getting Started • Tutorial
24
5 Choose the second song to be added in the list
with the TEMPO/VALUE buttons.
6 Press ENTER/YES to confirm the second song on
the list.
7 Add other songs to the list by following steps 5-
6.
8 Once the list is complete, press START/STOP to
play back all the selected songs.
The songs in SMF format 0 are played back at once.
If the song is in M-live (MidiSoft), Solton, or
Tune1000 or compatible (Edirol, GMX, KAR, HitBit,
XF format and contains lyrics, the lyrics appear on
the display in time with the music. If not, the dis-
play shows the standard information.
If the song is in M-live (MidiSoft), Solton, or GMX
format and contains chord abbreviations, the
abbreviations appear on the display in time with
the music.
The songs in SMF format 1 must be loaded in mem-
ory first, then after a few seconds wait they are
played back. If some backing sequences or a song
are already contained in the Song Edit mode, a
message will appear asking you if it is OK to erase
this data. If you don’t mind losing the data in mem-
ory, press ENTER/YES to start playback.
If you wish to retain the data, press EXIT/NO to
cancel loading. Switch to the Disk/Global mode
and save the song and backing sequences on
another disk. Then go back to the Song Play mode
and repeat the operation.
9 Press START/STOP to stop playback.
0 Press START/STOP again to re-start playback.
A Press EXIT/NO to exit the JukeBox mode.
To Next Page
Loading...
