KTM 1190 RC8 EU 2008 - Setting the Engine to Ignition Top Dead Center of the Rear Cylinder; Setting the Engine to Ignition Top Dead Center of the Front Cylinder

30/ENGINE 74
200524-11
– Position the horn holder. Mount and tighten screws .
Guideline
Remaining chassis screws M6 10 Nm (7.4 lbf ft)
200523-11
– Position the footrest bracket. Mount and tighten screws .
Guideline
Screw, front footrest
bracket
M8 25 Nm
(18.4 lbf ft)
Loctite
®
243™
– Position the shift shaft deflection. Mount and tighten screw  with the washers.
Guideline
Screw, shift shaft deflector
on shift shaft
M6 18 Nm
(13.3 lbf ft)
Loctite
®
243™
– Position the side stand bracket. Mount and tighten screws .
Guideline
Screw, side stand bracket M8 25 Nm
(18.4 lbf ft)
Loctite
®
243™
200522-11
– Position the chain securing guide with the spacer. Mount and tighten screws .
Guideline
Screw, shift shaft deflector
on chain securing guide
M6 10 Nm
(7.4 lbf ft)
Loctite
®
243™
Remaining chassis screws M6 10 Nm
(7.4 lbf ft)
–
200521-11
– Mount the slave cylinder with the spacer and sleeves. Mount and tighten screws .
Guideline
Remaining chassis screws M6 10 Nm (7.4 lbf ft)
– Mount the engine sprocket cover. Mount and tighten screws .
Guideline
Remaining chassis screws M6 10 Nm (7.4 lbf ft)
200520-11
– Plug in the connector of ignition coils .
– Install the exhaust system. ( p. 26)