190 General Maintenance
26. Once the chute has been reinstalled, put back the divider guard.
27. Reinstall the hopper divider.
28. Reinstall both anti-spill guards.
Rollers
If the roller itself has to be replaced because of wear, apply the following procedure:
1. Once the roller has been removed from the follower panel (see Follower Panels on page 179),
remove the external snap ring.
Figure 3-276
Removing external snap ring
2. Remove the washer.
Figure 3-277
Removing washer
3. Slide out the roller.
4. Reverse the previous steps to reinstall the roller.
To Next Page
Loading...
