General Maintenance 111
Figure 3-137
Flange bearing and holding bolts
27. To reinstall the chutes, reverse this procedure.
Fixed Chute (Co-Mingle Units W/ SSO Tipper)
EXPERT™ units that are equipped with an SSO tipper have a fixed chute in their hopper (see Figure
3-138). Usually, these units are used to collect organic waste along with other type of garbage since
the body is of co-mingle type (with two compartments). The work sequence towards removal of the
packer panel on a SSO tipper equipped E
XPERT™ is the following:
Remove the fixed chute (see procedure in this section)
Remove the hopper divider guard (see Step 6 of the procedure described in this section)
Remove the hopper divider (see Step 2 on page 63)
Remove the packer (see D. Removing Packer Panel - Co-Mingle Units W/O Loading Arm on
page 86)
Figure 3-138
Fixed chute and its components
Chute deflector
Chute
Chute
cap
Chute
support
Upper
reinforcement
To Next Page
Loading...
Need help?
General
