EasyManuals Logo

Labrie EXPERT Service Manual

Default Icon
425 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image
30 General Maintenance
Hopper
The area behind the packer SHOULD be cleaned out EVERY DAY. The packer will not work
properly if waste accumulates in this area; this could cause severe damage to the packer and other
related parts.
Cleaning the Hopper
This section explains how to properly clean the hopper section of the truck body.
NOTE: The following procedure may vary depending on what type of chassis the body is attached to
and what types of options are installed on the vehicle (e.g. crusher panel, glass compartment,
automated arm, etc.).
A. Units with a HELPING-HAND™ arm
NOTE: For units with no HELPING-HANDarm, go to page 35.
To clean the hopper of an E
XPERT™ vehicle equipped with a HELPING-HAND™ arm, apply the
following procedure:
1. Park the EXPERTon safe level ground.
2. Apply the parking brake.
3. Using the Packer Control Selector switch on the control panel (see Figure 3-1), select the right-
hand side packer control station.
Figure 3-1
Packer Control Selector switch
NOTE: This switch is found only on vehicles equipped with more than one packer control station.
Danger!
Always wear gloves, safety glasses, steel-toed footwear and proper clothing when
cleaning the hopper and body.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Labrie EXPERT and is the answer not in the manual?

Labrie EXPERT Specifications

General IconGeneral
BrandLabrie
ModelEXPERT
CategoryTrucks
LanguageEnglish

Related product manuals