General Maintenance 31
4. If needed, disengage the speed-up system by turning OFF any of the two Speed-Up switches on
the control panel: Speed-Up ON/Speed-Up Auto (see Figure 3-2).
Both switches must be blue lighted.
Figure 3-2
Speed-Up switches
5. If the truck is equipped with a chute, as in a co-mingle type unit, place it on the left-hand side of
the hopper.
NOTE: When a truck is equipped with a dual chute, the operator has to place both sections of the chute
on the left-hand side of the hopper. To know how to operate the chute, please refer to the
Operator’s Manual provided with the truck.
6. Raise the crusher panel fully using the Crusher Panel Up button on the packer control station
(see Figure 3-3).
Keep this button pressed until the crusher panel is completely raised.
Figure 3-3
Crusher Panel Up button
To Next Page
Loading...
Need help?
General
