9
Multiplexing
As Labrie Enviroquip Group vehicles become more
and more efficient, they require more automation
features and thus some programming. Currently,
E
XPERT™ vehicles require programming of:
Labrie’s CAN bus-based multiplexed system
the Allison transmission parameters, and
the Cummins engine parameters
The following pages provide the necessary
information for these tasks.
Labrie’s Multiplex System
Labrie has equipped your EXPERT™ unit with a CAN
bus-based multiplexed system, which integrates a
monitor, a control panel, a joystick, and a set of
electronic controllers. This whole system has been
designed to help you operate your unit in an efficient
and easy way. Labrie’s multiplexed system is reliable
and safe and it requires less wiring harnesses to
operate. It can also monitor various function status of
the body and display warning and caution messages.
Through its monitor (see Figure 9-1), Labrie’s
multiplexed system informs you of any malfunctions
that may occur during the operation of the truck.
Various caution and warning messages can be
displayed on the monitor, depending on the
seriousness of the situation. Yellow-highlighted
messages indicate that caution should be used while
red-highlighted messages indicate a warning situation
that must be dealt with quickly.
Figure 9-1
Monitor
To Next Page
Loading...
Need help?
General
