Safety 15
3. Switch off the hydraulic pump.
4. Turn off the engine, remove the key from the ignition, store it in a safe and controlled area
(preferably on yourself), and tape over the ignition switch.
5. Turn off and lock the master switch.
6. Chock all wheels.
IMPORTANT: Depending on the chassis model, the battery set of the EXPERT™ may be equipped with a master
switch (see Figure 2-2) that must be turned off.
Figure 2-2
Master switch
7. Put an “OFF SERVICE” tag on the driver’s wheel and on the front windshield.
8. Use safety props to block any system that could move by gravity (open tailgate, raised body, etc.).
9. Drain all air tanks.
10. Verify and inspect any security device and/or mechanism to make sure that there is no bypass
and that they are all functional.
Prior to Start Up
Before starting the vehicle:
1. Make sure no system will engage and/or start to operate as you start the engine.
2. Make sure the shut-off valve on the hydraulic tank is fully open before starting the vehicle
(see Figure 2-3).
To Next Page
Loading...
Need help?
General
