Labrie EXPERT - Page 42

32 General Maintenance
NOTE: If no right-hand side packer control station is installed, you may use the Crusher Panel Up
switch on the in-cab control panel (see Figure 3-4). Keep this switch pressed until the panel is
raised completely.
Figure 3-4 Crusher Panel Up switch on in-cab control panel
7. Using the arm joystick or the auxiliary arm controls below the right-hand side seat (if provided)
[see Figure 3-5], fully extend the H
ELPING-HAND™ automated arm (see Figure 3-6).
Figure 3-5 Auxiliary arm controls
Figure 3-6 H ELPING -HAND™ automated arm