General Maintenance 47
Follow these steps before proceeding with the removal of the packer panel:
1. Start the engine and engage the hydraulic pump.
2. Fully raise the crusher panel (if installed).
3. Using the joystick, extend the automated arm to get better access to the hopper area.
4. Fully retract the packer by pressing the yellow button on the packer control station.
5. Turn OFF the hydraulic pump and the engine.
6. Lock out and tag out the vehicle (see Locking Out and Tagging Out the Vehicle on page 14).
NEXT: ACCESSING PACKER: See “A. Accessing Packer - Standard Units W/ Loading Arm” on
page 50.
B. Preparing Packer for Removal - Standard Units W/O Loading Arm
Follow these steps before proceeding with the removal of the packer panel:
1. Start the engine and engage the hydraulic pump.
2. Fully raise the crusher panel (if installed).
3. Fully extend the packer, then push the red emergency STOP button to maintain the packer in its
fully extended position.
4. Turn OFF the hydraulic pump and the engine.
5. Lock out and tag out the vehicle (see Locking Out and Tagging Out the Vehicle on page 14).
NEXT: ACCESSING PACKER: See “B. Accessing Packer - Standard Units W/O Loading Arm” on
page 52.
C. Preparing Packer for Removal - Co-Mingle - W/ Loading Arm
Follow these steps before proceeding with the removal of the packer panel:
1. Start the engine and engage the hydraulic pump.
Danger!
Secure the area around the path of the automated arm when performing maintenance
or repair.
Danger!
Do not enter the hopper while the packer is moving.
Danger!
Do not enter the hopper while the packer is moving.