LeeBoy 685D - Lighting

Lighting
Inspect lights for proper operation daily. If a light or
group of lights does not function:
• Check the fuse box panel for a blown fuse.
• Examine all visible wiring connections, ensuring they
are not frayed or damaged, and securely fastened.
• Check lighting mounts for proper ground.
• Remove light lens or casing (if applicable) and check
bulb. Replace if needed.
• Inspect wiring harness for damage (see Schematics
in Section 6).
FLASHER
LOW
BEAM
HIGH
BEAM
WORK/
TRAVEL
SEAT
SWITCH
AUX
STEERING
F24
F23
F22 F20
F21
F19
KEY
10A
F18
F16 F14 F12
F10 F8 F6 F4
F2
F17
F15
F13
F11 F9 F7
F5 F3
F1
TAIL
LIGHTS
10A
10A
10A
10A
10A 15A
15A
15A
15A
20A
REAR WORK
LIGHTS
FLASHER
FRONT WORK
LIGHTS
BEACON/
FAN
REAR
WIPER
FRONT
WIPER
LOW
BEAM
HIGH
BEAM
AC/HEAT
10A 10A
10A 10A
10A 10A
10A
10A 10A
OPEN
OPENOPEN
OPEN
HORN/
DOME
DIAGNOSTICS
RADIO
FLOAT/
AWD
AUX
STEERING
OUTLET
WORK/
TRAVEL
PARK
BRAKE
ENGINE
Figure 5-25. Fuse Panel (Under Main Control Panel)
If broken wires are found, solder together and cover with
a shrink-wrap type of plastic covering (preferred) or
electrician’s tape to prevent contamination of the solder
joint by moisture.
If you make any repairs to the wiring harness on the
grader, always replace or repair the protective loom
covering the wiring to prevent future damage to the
wiring harness. Examine the routing of the harness and
ensure it is not subjected to excessive movement, which
often causes broken wiring.
5
Maintenance
LeeBoy 685D Motor Grader 5-23