5.2011.8583.0 C
Troubleshooting 7-27
5. Use a socket wrench (24 mm) (1) to turn the crank in its correct position. This can be a quarter of a
turn or more than a complete turn. During turning the closing belt drum in the grabber turns 6 times
as fast and you must guide the closing belt over the guide wheel when it rolls up. The crank (2) is in
the correct position when the middle of the shackle (3) is at the position of the arrow indicator (see
figure 73 on page 7-27).
Figure 73. Put the crank in its correct position
KEY: 1. Socket wrench - 2. Crank - 3. Shackle
in n o vato rs in agriculture
To Next Page
Loading...
