5.2011.8583.0 C
7-28 Troubleshooting
6. Position the end link (2) in the groove of the lower pin (3) (see figure 74 on page 7-28).
Chain in its correct position Put the end link over the groove
of the top pin
Figure 74. Chain in its correct position
KEY: 1. Top pin - 2. End link - 3. Lower pin - 4. Spring - 5. Safety handle - 6. Chain - 7. Top pin groove
7. While pushing the activation handle (5) downwards, put the end link (2) over the groove of the top pin
(1).
Risk of being crushed.
Slowly close the grabber to secure the position of the metal block.
8. Remove the metal block (2) (see figure 71 on page 7-25).
9. Connect the smartphone to the Feed Grabber.
10. Go to the page Testing > Test Grabber.
11. Use the buttons to open and close the grabber. Close the grabber to 0% and open it to 60%. Examine
if the grabber opens and closes properly.
The closing belt automatically rolls up on the drum in the top during closing.
Close up
1. Connect the smartphone to the Feed Grabber.
in n o vato rs in agriculture
To Next Page
Loading...
