5.2011.8583.0 C
Operating Instructions 5-21
2. Push the button
Alarms.
3. If there is an alarm on the Feed Controller or another device, it is shown in the list of Active alarms.
4. Read the alarm message and remove the cause of the alarm, if necessary see Troubleshooting to see
what actions should be taken to remove the alarm.
5. If there is an accept button behind the alarm message, push Accept to confirm the alarm message, no
further actions are necessary.
6. If there is an alarm on another device, this is shown in the list Active alarms.
Depending on the location of the alarm see:
• If the alarm is on the Mixing and Feeding Robot, Feed Grabber or Bridge Crane: (see page 5-21)
• If the Mixing and Feeding Robot gives the alarm that the automatic (barn) door is in error state:
(see page 5-21)
• If the alarm is on the additives dispenser (frequency pulse) (see page 5-22)
Restart the system with the smartphone
1. Connect the smartphone (see Connect the Smartphone to Device Software on page 5-15) to the Feed
Controller.
2. If there is an alarm on the Feed Controller it is shown on the display.
3. Read the alarm message, if necessary go to chapter Troubleshooting to see what actions should be
taken to remove the cause of the alarm.
4. Push
to confirm the alarm message.
5. If there is an alarm on another device go to the page Alarms > Active alarms.
6. Check on which device the alarm is generated.
7. Push
. If necessary go to chapter Troubleshooting to see what actions should be taken to remove
the cause of the alarm.
If the alarm is on the Mixing and Feeding Robot, Feed Grabber or Bridge Crane:
1. Start the Lely control app and connect the smartphone to the software of the device.
2. Read the alarm message, if necessary go to chapter Troubleshooting to see what actions should be
taken to remove the cause of the alarm.
3. Push
to confirm the alarm message.
If the Mixing and Feeding Robot gives the alarm that the automatic (barn) door is in error state:
1. Remove any blockage from the automatic door.
2. Make sure the sensor is still in the correct position and can detect that the door is open or closed.
3. Use the buttons on the controller of the supplier of the door to reset the alarm of the door as follows:
in n o vato rs in agriculture
To Next Page
Loading...
