Page 233
MegaRAID SAS Software User Guide Chapter 6: MegaRAID Storage Manager Overview and Installation
| Installing MegaRAID
Storage Manager
1. Copy the “MegaRaidStorageManager-SOLSPARC-8.10-…….tar.gz” file to a
temporary folder.
2. Untar the “MegaRaidStorageManager-SOLSPARC-8.10-…….tar.gz” file using the
following command:
tar -zxvf
“MegaRaidStorageManager-SOLSPARC-8.10-…….tar.gz”
This step creates a new disk directory. Go to the new disk directory, and find and
read the readme.txt file.
3. Enter the Bash shell.
4. Execute the command ./install.sh present in the disk directory.
5. When prompted by the installation scripts, select Y to complete the installation.=
6.4.4 Installing MegaRAID Storage
Manager Software for Linux
Follow these steps if you need to install MegaRAID Storage Manager software on a
system running Red Hat Linux or SUSE Linux:
1. Copy the MegaRaidStorageManager-SOLX86-…..tar.gz file to a temporary folder.
2. Untar the MegaRaidStorageManager-SOLX86-…..tar.gz file using the following
command:
tar -zxvf MegaRaidStorageManager-SOLX86-…..tar.gz
A new disk directory is created.
3. Go to the new disk directory.
4. In the disk directory, find and read the readme.txt file.
5. To start the installation, enter the following command:
csh install.sh -a
If you select Client installation for a PC used to monitor servers, and if there are no
available servers with a registered framework on the local subnet (that is, servers with a
complete installation of MegaRAID Storage Manager software), the server screen
appears. The server screen does not list any servers. You can use this screen to manage
systems remotely.
To install the software using interactive mode, execute the command ./install.sh
from the installation disk.
To install the product in a non-interactive or silent mode, use the command
./install.sh [-options] [ -ru popup] from the installation disk. The
installation options are:
Complete installation
Client Component Only
StandAlone
The -ru popup command will remove popup from installation list.
You also can run non-interactive installation using the RunRPM.sh command.
The installer offers three types of setup options:
Complete - This installs all the features of the product.
To Next Page
Loading...
Need help?
General