Page 241
MegaRAID SAS Software User Guide Chapter 6: MegaRAID Storage Manager Overview and Installation
| Installing and Configur-
ing a CIM Provider
NOTE: Uninstall all the previous versions of SASProvider before you install this
version. You can check all of the installed versions of SASProvider by using the
command rpm -qa | grep LsiSASProvider .
Perform the following step to install a CIM SAS Storage Provider on a Linux system.
Install the SAS Provider using the Red Hat Package Manager (RPM) by entering the
following command:
rpm -ivh
The RPM installs all of the necessary files and the Managed Object Format (MOF),
and it registers the libraries. The Provider is now ready to use.
NOTE: After you install CIM SAS Provider, the MOF file LSI_SASRaid.mof is
available under the /etc/lsi_cimprov/sas/pegasus/common directory.
Perform the following step to un- install a CIM SAS Storage Provider on a Linux
system.
Remove CIM SAS Provider by entering the command:
rpm –ivh LsiSASProvider-<version>.<arch>.rpm"
This removes all of the necessary files, uninstalls the MOF, and unregisters the
libraries. The SAS Provider is no longer on the system.
NOTE: tog-pegasus binaries, such as cimmof, cimprovider, and wbemexec, should be in
PATH variable of /etc/profile, and hence, should be defined in all environments of
the system.
For Pegasus version 2.5.x, perform the following steps:
1. After you install the SAS Pegasus provider, verify that libLsiSASProvider.so
and libLsiSASProvider.so.1 are in /usr/lib/Pega
sus/providers dire
ctory.
If these files are not present, copy libLsiSASProvider.so.1 from
/opt/tog-pegasus/providers/lib to /usr/lib/Pegasus/providers and
create a symbolic link libLsiSASProvider.so to
/usr/lib/Pegasus/providers/libLsiSASProvider.so.1 at
/usr/bin/Pegasus/providers.
2. Restart Pegasus CIM Server and SASServer by performing the following steps:
— To start the tog-pegasus server, execute the following command:
# /etc/init.d/tog-pegasus restart
— To start SASSever, execute the following command:
# /etc/init.d/LsiSASd restart
6.6.2 Installing a CIM SAS Storage
Provider on Windows
The following procedure describes how to install and un-install the CIM SAS Storage
Provider on a system running on a Windows operating system.
Perform the following steps to install a CIM SAS Storage Provider on a Windows system.
To Next Page
Loading...
Need help?
General