Page 276
MegaRAID SAS Software User GuideChapter 8: Configuration
| Changing Adjustable Task Rates
8.4 Changing Adjustable
Task Rates
Follow these steps if you need to change the adjustable rates for rebuilds, and other
system tasks that run in the background:
NOTE: We recommend that you leave the adjustable task rates at their default settings
to achieve the best system performance. If you raise the task rates above the defaults,
foreground tasks will run more slowly and it might seem that the system is not
responding. If you lower the task rates below the defaults, rebuilds and other
background tasks might run very slowly and might not complete within a reasonable
time. If you decide to change the values, record the original default value here so you
can restore them later, if necessary:
Rebuild Rate: ____________
Background Initialization (BGI) Rate: ____________
Check Consistency Rate: ____________
1. Select a controller icon in the Physical tab or the Logical tab in the left panel of the
MegaRAID Storage Manager window.
2. Select Go To>Controller>Set Adjustable Task Rates from the menu bar, as shown
in Figure155.
Figure 155: Set Adjustable Task Rates Menu
The Set Adjustable Task Rates screen appears, as shown in Figure156.
To Next Page
Loading...
Need help?
General