• For the locations of connectors on the processor board, refer to “System-board-assembly connectors” on
page 33
.
• To connect power cables for 2.5-inch drive backplanes, refer to
“Power/Sideband cable routing” on page
244
.
• To connect power and input cables for CFF RAID/HBA adapters, refer to
“CFF RAID/HBA adapter” on
page 222
.
• To connect power and sideband cables for the rear drive backplane, refer to
“Rear NVMe/SATA drive
backplane” on page 232
.
• To connect power and sideband cables for the 7mm drive backplane, refer to
“7mm drive backplane” on
page 235
.
• To connect cables for RAID flash power modules, refer to
“RAID flash power modules” on page 227.
To connect signal cables for a backplane for 4 x 2.5'' AnyBay front drives, refer to the following cable routing
scenarios depending on your server configuration:
•
“Cable routing with an SFF HBA/RAID adapter” on page 255
Cable routing with an SFF HBA/RAID adapter
The following illustrations and tables show the mapping relationship between backplane connectors and an
8i SFF RAID adapter (Gen 3 or Gen 4).
Chapter 6. Internal cable routing 255
To Next Page
Loading...
