Cable routing with a CFF RAID/HBA adapter and 2x 2.5 rear SAS/SATA drives
Note: Gen 3 and Gen 4 16i CFF RAID/HBA adapters are slightly different in their connector locations, but the
connection method is similar. The following illustration takes Gen 4 16i CFF RAID/HBA adapters as an
example.
Figure 205. Cable routing for 6 front SAS/SATA drives and 4 front AnyBay drives bays and a 16i CFF RAID adapter (Gen
3/ Gen 4) with 2 x 2.5 rear SAS/SATA drives installed
Table 46. Mapping between one front AnyBay backplane and a 16i CFF RAID adapter (Gen 3) with 2 x 2.5 rear SAS/SATA
drives installed
From To
1 SAS 0 on the front backplane 1 C0 on the CFF RAID/HBA adapter
2 SAS 1 on the front backplane 2 C1 on the CFF RAID/HBA adapter
Chapter 6. Internal cable routing 275
To Next Page
Loading...
