Note: The following uses riser 1 assembly as an example for illustration. The replacement
procedure is the same for riser 2 assembly.
Figure 71. Removing the riser assembly
1. Open the blue latch on the GPU air baffle.
2.
Loosen the screw that secures the riser assembly.
3.
Grasp the riser assembly by its edges and carefully lift it straight up and off the chassis.
• GPU adapter on riser 3 assembly
1. Open the blue latch on the GPU air baffle, slightly lift the riser assembly up, and remove the
air baffle.
2. Disconnect the GPU power cable and riser 3 cables from the system board assembly.
Notes:
Chapter 5. Hardware replacement procedures 111
To Next Page
Loading...
