Lenovo ThinkSystem SR650 V3 7D75 - Page 124

Figure 74. Installing the GPU adapter
a.
Open the blue latch on the riser cage.
b.
Align the GPU adapter with the PCIe slot on the riser card. Then, carefully press the GPU
adapter straight into the slot until it is securely seated.
c.
Close the blue latch.
Step 4. Install the riser assembly with the GPU adapter.
• GPU adapter on riser 1 or 2 assembly
1. Install the GPU air baffle.
(Optional) If a single-wide FHFL GPU adapter is to be installed on slot 1, 4, or 7, but the
adjacent slot will be left empty or installed with a half-length adapter, install an add-on air
baffle 1 on the GPU air baffle first.
Figure 75. Installing an add-on air baffle 1
2. Connect the GPU power cable. See Chapter 6 “Internal cable routing” on page 271.
3. Install the riser assembly with the GPU adapter.
114
ThinkSystem SR650 V3 User Guide