Figure 76. Installing the riser assembly
a. Align the riser card with the PCIe slot on the system board assembly. Carefully press
the riser card straight into the slot until it is securely seated.
b.
Open the blue latch on the GPU air baffle and fix the end of the GPU adapter. Then,
close the blue latch.
c.
Tighten the screw to fix the riser cage.
4. (Optional) If the riser card (E/x16/x16) is used and a single-wide FHFL GPU adapter is
installed on slot 2 or 5, install an add-on air baffle on the GPU air baffle after installing the
GPU adapter.
Chapter 5. Hardware replacement procedures 115
To Next Page
Loading...
