Lenze i55AE155F

5.5 Save parameter sengs in the memory module
5.5.1 Save parameter sengs with keypad
If one parameter seng has been changed with the keypad but has not been saved in the
memory module with mains failure protecon, the SET display is blinking.
In order to save parameter sengs in the user memory of the memory module, press the key-
pad enter key longer than 3 s.
MAN MAN MANAUTO AUTO AUTOLOC LOC LOCREM REM REM
VEL Saving Parameters Parameters S aved :FLEX:AIN1
SET SET SET
> 3 s
0 0 0 S T O P S A V I N G P S P
S
A
V
E D
5.5.2 Save parameter sengs with »EASY Starter«
If a parameter seng has been changed with the »EASY Starter« but not yet saved in the
memory module with mains failure protecon, the status line of the »EASY Starter« displays
the note "The parameter set was changed".
In order to save parameter sengs in the user memory of the memory module,
•
click the buon in the toolbar of the »EASY Starter« or
•
press the funcon key <F6> or
•
execute the device command "Save user data": 0x2022:003 (P700.03) = "On / start [1]".
Commissioning
Save parameter sengs in the memory module
Save parameter sengs with »EASY Starter«
107