Lenze i55AE155F

Parameter Name / value range / [default seng] Info
0x2550:011
(P707.11)
Brake resistor: Response to error
(Brake resistor: Error response)
•
For further possible sengs, see parameter
0x2D45:001 (P310.01). ^ 223
Selecon of the response to be executed when the error threshold for
brake resistor monitoring is reached.
Associated error code:
•
65282 | 0xFF02 - Brake resistor: overload warning
3 Fault
11.5.2 Stopping the deceleraon ramp funcon generator
The deceleraon ramp funcon generator is stopped for a short me if the voltage threshold
for braking operaon is exceeded.
Details
When this braking method is selected, the maximum permissible me for the deceleraon
override has to be set in 0x2541:005 (P706.05).
•
If the DC-bus voltage does not fall below the voltage threshold for braking operaon
shown in 0x2541:002 (P706.02) within this me, the motor is decelerated further.
•
The me is only reset if the voltage threshold shown in 0x2541:002 (P706.02) is not
reached.
Addional funcons
Brake energy management
Stopping the deceleraon ramp funcon generator
447