General Information 1-89
5055-01X
3. Rotate the adjustment knobs as needed to align the holes in the
finisher with the pins.
To raise the finisher, rotate the adjustment knobs clockwise.
To lower the finisher, rotate the adjustment knobs
counterclockwise.
4. Roll the finisher toward the printer until the finisher locks to the
docking plate pins.
You hear a click when the finisher locks into position.
If the pins go into the holes but the finisher did not lock to the
pins, go to “Aligning the Sides of the Finisher” on
page 1-90. Otherwise, go to “Aligning the Top of the
Finisher” on page 1-92.
To Next Page
Loading...
