General Information 1-79
5055-01X
Finisher Installation
Attaching the Docking Plate and Guide Rail
1. Lift the printer exit tray halfway and remove. You will need the
tray when the finisher is attached.
2. Insert the docking plate tabs into the printer.
3. Align the thumbscrews on the docking plate with the holes in the
side of the printer.
4. Tighten the docking plate thumbscrews.
5. Align the thumbscrews on the guide rail plate with the holes in
the side of the printer cabinet or stand.
To Next Page
Loading...
