4-80 Service Manual
5055-01X
HCF Paper End Sensor Removal
HCF Paper Size Sensors (1, 2) Removal
1. Cover the paper level sensor with your hand and press the
down button. The tray moves down. Lower the tray until the
down sensor turns on.
2. Remove the front cover and transfer cover.
3. Remove the two screws on the front and rear sides of the side
fence.
4. Mark the locking position of the side fence locking stay.
5. Remove the two screws on the side fence locking stay.
6. Remove the screw and connector from paper end sensor, and
remove the sensor.
7. Remove the screw and connector from the clamp plane and
remove the paper size sensors 1 and 2.
To Next Page
Loading...
