Diagnostic Aids 3-21
5055-01X
Device Tests
Quick Disk Test
The Quick Disk Test performs a non-destructive read/write on one
block per track on the disk. The following message appears while the
test is running:
The Power indicator blinks while the test is in progress. If the test is
successful, the following message is displayed:
Press Go, Return, or Stop to return to the DEVICE TESTS screen.
If the test fails, then the following message is displayed:
Press Go, Return, or Stop to return to the DEVICE TESTS screen.
You cannot cancel this test.
Disk Test/Clean
The Disk Test/Clean Test causes the disk to be formatted, destroying
all data on the disk and should not be attempted on a good disk.
This test should only be used when the disk contains unusable data.
Note: This can be an extremely lengthy test depending on the disk
size, and leaves the disk unformatted.
To run this test, select Disk Test/Clean from the DEVICE TESTS
menu. The following message appears to warn the customer that all
disk contents will be lost:
To continue with the test, press Go.
Quick Disk Test
Testing...
Quick Disk Test
Test Passed...
Quick Disk Test
Test Failed...
Files will be
lost Go/Stop?
To Next Page
Loading...
Need help?
General
