Repair Information 4-23
5055-01X
Gear Cover Removal
Multipurpose Feeder Roll Removal
Multipurpose Feeder Clutch Removal
OHP Detection Sensor (Upper) Removal
1. Open the top unit, and remove the upper cassette, front cover,
multipurpose feeder, right side cover, and turn guide.
2. Remove the two screws from the gear cover, and remove the
cover.
3. Remove the four screws from the multipurpose feeder frame
and the ground board screw.
4. Disconnect the connector of the multipurpose feeder paper feed
sensor.
5. Pull out the multipurpose feeder frame slightly.
To Next Page
Loading...
