4-24 Service Manual
5055-01X
6. Remove the screw from the OHP detection sensor (upper).
7. Turn the bearing stopper of the multipurpose feeder roll forward
1/4 turn and remove upward.
8. Remove the C-clip and remove the multipurpose feeder clutch.
Note: After reassembling the components, coat the contact areas of
the multipurpose feeder roll shaft and multipurpose feeder ground
plate with conductive grease. If the paper feed roller surface is
stained by oil or other contaminant, clean with cloth moistened with
alcohol.
To Next Page
Loading...
