General Information 1-65
5055-01X
Finisher
The 5055-01X finisher communicates with the host engine through
serial interface signals and performs the following operating modes:
• Straight - exits paper to the upper tray.
• Punch and straight - stops paper at the leading edge, punches
it, and exits it to the upper tray.
• Invert - sends paper to the accumulator, and exits it to the lower
tray.
• Punch and invert - stops paper at the leading edge, punches it,
and sends it to the accumulator where it exits to the lower tray.
• Invert and staple - jogs each sheet of paper in the
accumulator. When the accumulated number of sheets reaches
a designated number, it staples a batch of sheets, and then
exits the stapled set to the lower tray.
• Punch, invert and staple - stops paper at the leading edge,
punches it, sends it to the accumulator and jogs each sheet.
When the accumulated number of sheets reaches a designated
number, the batch is stapled, and exited to the lower tray.
• Invert and offset - jogs each paper in the accumulator, shifts it
by the offset, then exits it to the lower tray.
• Punch, invert and offset - stops paper at the leading edge,
punches it, sends it to accumulator and jogs each page, offsets
it, and then exits it to the lower tray.
Note: Capacity - up to 100 sheets of 20 lb. paper in tray 1 (top tray)
up to 1000 sheets of 20 lb. paper in tray 2 (lower tray).
To Next Page
Loading...
