3-22 Service Manual
5055-01X
To exit the test immediately and return to the DEVICE TESTS
screen, press Return or Stop. The Power indicator blinks while the
test is in progress. Once Go is selected, the following screen is
displayed to indicate the operation has begun:
If the test is successful, the following message is displayed.
Press Go, Return, or Stop to return to the DEVICE TESTS screen.
If the test fails, the following message appears:
Press Go, Return, or Stop to return to the DEVICE TESTS screen.
You cannot cancel this test.
Flash Test
The Flash Test writes and reads data to the flash device, destroying
all data, leaving the flash unformatted. The servicer must reformat
the flash using the Format Flash menu operation. To run this test,
select Flash Test from the DEVICE TESTS menu. The following
message appears warning the customer that all flash contents will
be lost:
To continue the test, press Go. To exit the test immediately and
return to the DEVICE TESTS screen, press Return or Stop.
The following message is displayed while the test is running:
Disk Test/Clean
Testing...
Disk Test Clean
Test Passed
Disk Test/Clean
Test Failed
Files Will be
Lost Go/Stop?
Flash Test
Testing
To Next Page
Loading...
Need help?
General
