1-100 Service Manual
5055-01X
3. Determine if the edge of the bottom of the page is below or
above the top edge of the page.
4. Loosen the guide rail thumbscrews.
Note: Do not move the adjustment knobs more than three complete
turns from their starting position. Adjustments greater than three
turns may cause paper jams.
5. Rotate both adjustment knobs the same amount to raise or
lower the side of the finisher.
A half turn of the knob moves the position of the hole
approximately one third to one half the distance of the punched
hole.
To move the bottom of the paper down, rotate the knobs
clockwise.
To move the bottom of the paper up, rotate the knobs
counterclockwise one quarter turn.
6. Tighten the guide rail thumbscrews.
7. Print and punch another piece of paper.
8. Repeat steps 2 and 3. If the holes are not aligned repeat steps 3
through 8.
To Next Page
Loading...
