Diagnostic Information 2-81
5055-01X
Paper jammed in Finisher Area H
2 • Paper Feed
Motor
• Finisher
Control
Board
Check the paper feed motors by running the staple
test or hole punch test in diagnostic mode.
If the paper feed motor has been replaced, replace
the finisher control board.
FRU Action
1 • Timing Belts
• Patting Roller
Check finisher to printer alignment. Go to “Aligning
the Finisher and Printer” on page 1-86.
Check for obstructions in the paper path. Check all
belts for wear or damage.
Check for wear or damage on the patting roller.
2 • Path Select
Solenoid
• Path Select
Gate
• Guide Stack
Assembly
• Jogging
Assembly
• Tractor Drive
Motor
• Tractor Belts
• Jogging
Motor
• Stapler
Check for proper operation of the guide stack
assembly and jogging assembly by running the
staple test in diagnostic mode. Check the tractor
belts for proper alignment.
Replace parts as necessary.
To Next Page
Loading...
