Diagnostic Information 2-83
5055-01X
Paper jammed in Area I
FRU Action
1 Timing Belts Check finisher to printer alignment. Go to “Aligning
the Finisher and Printer” on page 1-86.
Check the paper path for obstructions. Check all
belts for wear or damage.
2 • Invert (Tray 2)
Exit Roller
• Exit Guide
(Tray 2) Invert
Assembly
• Exit Guide
(Tray 1)
Straight
Assembly
Check to ensure that all rollers are operating
correctly by running the hole punch and staple tests
in diagnostic mode.
3 • Paper Exit
Sensor
(Tray1)
• Paper Exit
Sensor
(Tray 2)
• Paper Full
Sensor A
(Tray 2)
• Paper Upper
Level Sensor
B (Tray 2)
Ensure that the sensors are working properly by
running the sensor test in diagnostic mode.
4 • Elevator
Upper Limit
Sensor
• Elevator
Lower Limit
Sensor
• Elevator
Motor
Ensure that the elevator upper limit sensor, elevator
lower limit sensor, and the elevator motor are
operating correctly at power up.
To Next Page
Loading...
