Diagnostic Aids 3-19
5055-01X
Finisher Sensor Test
This test determines whether or not the finisher sensors and
switches are working correctly. To run the test, select the Sensor/Sw
Test operation from the Finisher Tests top level menu. The following
sensors and switches are listed in the bottom level menu:
• Input Path
• Paper Register
• Tray 1 Exit
• Tractor Home Pos.
• Paper Full A
• Paper Detect
• Staple Home Pos.
• No Staple
• Punch Box Detect
• Invert Path
• Tray 2 Exit
• Elev. Upper Limit
• Tray Near Full
• Elev. Lower Limit
• Jogging Home Pos.
• Pap. Upper Level
• Fin. Set Switch
• Staple Cart. Set
To select one of the sensors/switches above, press Menu until the
sensor/switch is displayed. Press Select. The following is a sample
screen that may be displayed:
Once the screen is displayed, you can manually actuate each of the
sensors or switches. When the sensor is closed, CL is displayed.
Likewise, when the sensor is open, OP is displayed. If the wrong
message is displayed, then the sensor is malfunctioning.
To exit the senor test, press Return or Stop.
Input Path
CL
To Next Page
Loading...
