Lexmark MS310 4514-220 - License List; Defaults; Edge to Edge; Continuous Tray 1 Simplex Print Test

The report consists of four pages. The printer always uses media from Tray 1 to print this report. It will not prompt
for a change in media regardless of the media type in Tray 1.
Note: This test cannot be canceled after it has begun. If duplex is activated, then the report is printed in
duplex.
To print the Print quality pages:
From the Diagnostics menu, navigate to Print Tests > Print Quality Pages.
License List
This prints a report containing the installed licenses.
Defaults
Warning—Potential Damage:
Modification
of the printer setting defaults causes the NVRAM space to be
restored to the printer factory settings.
This setting is used by the printer to determine whether US or non-US factory default values should be used.
The following printer settings have dierent US and non-US values:
Printer default values US value Non-US value
Paper sizes setting in the General settings menu U.S. Metric
Default paper size (paper feeding sources which do
not have hardware size‑sensing capability)
Letter A4
Default envelope size (envelope feeding sources
which do not have hardware size‑sensing capability)
10 Envelope DL Envelope
Fax media size Letter A4
PCL symbol set PC-8 PC-850
PPDS code page 437 850
Universal units of measure Inches Millimeters
Available options:
• U. S.
• Non‑U.S.
Edge to Edge
When set to On, this shifts all four margins (top, bottom, left, and right) to the physical edge of the page (printable
area of a supported paper size).
Continuous Tray 1 Simplex Print Test
This initiates a continuous tray 1 simplex print test. To stop the test, press X.
4514-2xx
Service menus
162