7 Remove the two screws (A) securing the reverse solenoid.
A
ACM clutch removal
1 Remove the left cover. See “Left cover removal” on page 194.
2 Remove the right cover. See “Right cover removal” on page 209.
3 Remove the main drive gearbox. See “Main drive gearbox removal” on page 195.
4 Remove the rear door and cover. See “Rear door and cover removal” on page 256.
5 Remove the power supply. See “Power supply removal” on page 239.
6 Remove the power supply shield. See “Power supply shield removal” on page 240.
7 Remove the duplex. See “Duplex removal” on page 241.
8 Disconnect the cable JFSOL from the controller board.
9 Secure right end of the shaft (A) with a pair of needle-nose pliers to prevent it from rotating.
4514-2xx
Parts removal
204
To Next Page
Loading...
